Customer Reviews for VEVOR Propane Forge Portable, Single Burner Tool and Knife Making, Large Capacity Blacksmith Farrier Forges, Mini Furnace Blacksmithing, Gas Forging Tools and Equipment, Complete Kit

Waw, je suis débutant forgeron, mais avec vevor, on se sent professionnel tout le temps

excellent for 1 burner takes no time at all

Very satisfied

Great, but missing the refractory cement. The ceramic fibers can lung damage if not sealed away. This forge works best if you add some bricks the the back end to keep the heat in.

Vert Handy use it for a branding furnace in my farm just for to be careful not to get it to hot 🔥

I bought this as my first forge and it performs very well. There are considerations and care that must be taken when using it, but this should be expected of any forge at this price point. I coated the firebox using a stiffening spray and then 3-4 coats of refractory cement to isolate and trap the insulation fibers and retain the heat. It's possible to use the forge if you skip this step, but it becomes a respiratory hazard if you're working in an enclosed space and this is true of all mineral wool forges. I also added additional firebricks at the front and rear as doors to further isolate the heat. Again, you can get metal to forging temperature without these, but they will save a lot of fuel and keep your shop much cooler while allowing you to reach higher temperatures. All in all I had no problems with the regulator or burner and once you get it dialed in you can forge some pretty significant pieces in this little thing. I've worked 1/2" square stock and 3/8"x1" flat stock without issue - it will get there if you're patient and running at the right fuel/air ratio. I find I use about 1-2 lbs of propane per hour of forging.

This is the second one of these I’ve bought. I went a little crazy with flux while learning to forge and it ate up my refractory cement. I just bought a new one Vice trying to repair the old one. Works well for smaller projects.

My first forge, it worked very well for my beginner projects. I would highly reccomend it, although the one downside was it's size. it doesn't do well with anything other than blades and flat projects

Works great and not a bad price. Recommend getting your own refractory cement for the insulation (not good to breath in the dust), perfect for starting out!

This kit is great for beginners looking to start with small forging items. Well worth it for introducing to setting up a forge too.