VEVOR Hairpin Table Legs 28" Black Set of 4 Desk Legs 880lbs Load Capacity (Each 220lbs) Hairpin Desk Legs 3 Rods for Bench Desk Dining End Table Chairs Carbon Steel DIY Heavy Duty Furniture Legs

No they don't adjust. They are true to size and very sturdy

Sorry,The height of this Table Legs is fixed. We don't have the 29.25" model.

No way...unless you want to put some kind of wood blocks on to mount which would would be a mess...

The feet are not adjustable

Nope.

They have to be ordered by length. They can not be adjusted

I’m sorry but I doubt it

It's would be fine mine is an inch too and they are perfect

I would measure the length. If it's an inch long then you'll need a smaller screw. TO compensate use wood glue for added strength

screws are 1", the bracket gives you a "very little" leeway./

It has been a while since I made three tables with the Hairpin legs, they were gifts, so I cannot measure, but my wood was 1/2 thick walnut. The screws held well and did not penetrate the top. I hope this helps.

I don’t know exactly how long they are, maybe an inch long. We used shorter screws we already had on hand. The piece of wood we used was only 3/4 in thick.

Sorry for the late reply. The srews are just alittle over 1 inch.

As a DYI person, I don't really see how wheels could be added to the legs.

I would say "no" unless they were "side wheels" and you did not plan to have anything heavy on top. But overall, I would say NO.

I don't think you can attach wheels to the legs

It of any size. There is a small maybe 1” flat plate on the bottom of the legs. It would be difficult to do unless you could glue some on.

I wouldn't think so. There would be nowhere to attach them.

No. Not in a practica fashion. The bottom of the legs are rounded metal rods.

The mounting holes are 2” between, but could probably be altered to work.

2 & 1/16 between holes.

The holes on these legs are 2 inches apart four holes total hope that helps

I measured from center of screw to center of next screw. It measured 2 1/4 " apart.