Home Electrical Power Distribution Voltage Transformers Variable Frequency Drive

VEVOR Variable Frequency Drive, AC 110V Input 2.2KW Variable Frequency CNC Drive Inverter Converter, VFD 3HP 1 or 3 Phase Input, 3 Phase Output, CNC Motor Inverter Converter for Motor Speed Control

Power: 2.2kw

Questions and Answers

12 Questions

1- Does the "RUN" capacitor stay in the circuit? 2- Can I program the motor RPM to be 2400 RPM. This would enable me to use the 2400 RPM pulleys on my lathe and the motor RPM would match the lathe spindle RPM. 3- The motor is a 1725 RPM, what is the maxium RPM that could be obtained using the VFD?

Answer This Question

1 The capacitor of the frequency converter is always in use during the working process. 2 You can set the motor speed to 2400 rpm. 3 The maximum speed of the inverter can reach 60,000 rpm, but the rated speed of the motor must be consistent with the rated speed of the inverter. It is best not to exceed the rated speed of the motor.

By vevor

Helpful? 2

If the equipment is shut down nd the power is disconnected from the inverter, will The previous settings be retained for next use? Happy

Answer This Question

The previous parameters will be retained, and the parameters will not be lost after powering off.

By vevor

Helpful? 2

Is there a place to download a PDF manual for this VFD?

Answer This Question

Here is the link to the manual: https://d2v0huudrf11kh.cloudfront.net/vevor-center-goods/H100manualV1.8%EF%BC%88%E6%96%B0%E5%91%BD%E5%90%8Dls%EF%BC%89%281%29%281%29_1653643426582.pdf

By vevor

Helpful? 2

How do you make the display show the motor rpm? Pressing the << button only shows the frequency, and other info but not the revolutions per minute.

Answer This Question

If you want to display the speed, you need to set it in the parameters. First, you need to set the parameter F185 to 4, and then set the parameter F170 to 2.

By vevor

Helpful? 1

This VFD produces a 3-phase output. But can we simply connect a single phase motor to two of the output terminals and run it with this VFD? In other words, can we use ONE of the three output phases to run a single phase motor?

Answer This Question

If the motor power is below 1KW, this inverter can be applied, because the current will be very large when the single-phase connection is used. The motor wire is connected to the two terminals U and W of the inverter.

By vevor

Helpful? 1