VEVOR Differential Housing Spreader for Dana Axles Fits for 30 44 60 70 &80 Series (Black)

Worked without any hiccups whatsoever

It does what it says it will do. I'm currently using it on a Dana 70HD rearend. It is well built and stout.

Works great. Same as the high priced spreader from the gear guys. Direct fit on Dana. Made an adapter out of 1/4 plate for Ford 8.8

Just rebuilt a Dana 60 and used this to spread the case for easier in/out of the carrier. Good and I say the fair and correct price seeing as the name brand tool makers charge $300 (nitro) and $600 (Yukon) for few pieces of metal welded into a simple fixture. But the Tool served its purpose well and I have no complaints

Worked as well as the $800 model purchased elsewhere. Ring and pinion destroyed, replaced in no time and preload was good. Thank you.

Worked very well, made job a whole lot easier and faster.

This diff spreader worked perfectly for me. Probably my second favorite tool in the garage mostly because of how much time it saved me. A few years ago I pulled my front carrier without a spreader and it literally took me an hour and a half of prying and hammering to get it out.Once I got this heavy sucker in place it took mabe 15 minutes and a couple little taps with a rubber hammer.My jeep has a 4 in lift and I jacked it up as high as I could get it then removed the wheels and let it down as far as the limit straps would go and the diff spreader fit right on there.

Awesome case spreader, it worked very well as intended!

Very well made and very heavy duty. I weighs 38 lbs. It's either powder coated or painted in a heavy enamel paint. I used on a Dana 60 rear end and it worked great. It doesn't need assembly instructions. It's very easy to figure it out. I agree with someones other comment that if you can't figure out how to assemble it. You should not be rebuilding the rear end.

Used on a Dana 60 to change ring and pinion , bearings and seals. Worked well. Must be assembled but is easy to assemble.