Customer Reviews for VEVOR 3 Point Ballast Box, 800lbs Capacity Hitch Ballast Box, Standard 2'' Hitch Receiver, Tractor Ballast Box with 5cu.ft Volume, Heavy Duty Steel, Fits Category 1 Tractor Attachment, Red

My only complaint is the linchpin pins for the lower arms. The holes to take the locking pins are drilled too close to get these pins. I temporarily had to use 1/4 inch bolts with nuts until I can get some smaller diameter ones from Amazon or Tractor Supply

This box is solid and it works well. Easy on and off. It supports plenty of weight and off sets my bucket nicely.

Arrived without damage or issue. Fitted perfectly onto Kubota BX25. Small piece of landscape fabric to cover up drain holes in bottom and slide door on back. Filled with 150lbs of soft sand. Tractor more stable when FEL full of mulch. Will add more sand before loading FEL with rock. Quality box, perfect for task. Vertical interior tubes hold two long handled tools in each (rake, bedding fork, brush, loppers, etc), very useful for my homeowner landscaping tasks. Hitch receiver is a bonus. Paint good and thick. Stable in motion after tightening 3 point hitch. Welds look good. No faults so far and most cost effective box at this time.

Because of the very reasonable cost I was afraid it might not be too good of quality. I was happily surprised when it arrived earlier than I expected and it was much better than I expected.....looked great in every respect, paint, welds and overall quality. I installed on a Massey Ferguson subcompact GC1715 tractor and it fit perfectly, after filling with sand I tried it out and it made a whole new machine out of this tractor as far as traction and stability are concerned plus the red color was a perfect match for the tractor. I am completely satisfied with this product and would wholeheartedly recommend it to others!

This ballast box is well built and a good value. There was a small problem with the order and the seller addressed it promptly and to my satisfaction. Seller stands behind product.

My ballast box arrived ahead of schedule in an undamaged package. Unlike other reviews there were no problems with the pin size or pin hole alignments. It was a great pleasure to buy this box and have it arrive undamaged unlike most people’s experiences.If you need an inexpensive ballast box then give this one a try.

I wish they had quality control, the lifting pins. the holes on the box are not the size of the screw part of the pin, since I had to drill them out with what I had. one side fit good the other? needs to have a quality check when cutting the holes I assume there plasma cut. but seems someone should have caught that before paint. otherwise the box is what it's supposed to do. once I get the hole bigger and fill it, then will find out.

As advertised, holds allot of material, provides plenty of ballast, good alternative to fluid in tires, like the tow hitch inlet.

The lift arm pins supplied are not quick-hitch compatible. To mount quick-hitch bushings you need to either drill new holes for the roll pins or just replace the whole pin with ones that have the right hole. I opted for new pins at $7 each from TSC.

Good item, welds are a little skimpy but more than strong enough. Arrived without door so now I have to make one but all in all worth the buy.