Ours arrived bent in one corner, the corner welds for the frame busted too. Most of the welds on this are just tack welds, which would normally be fine.Assembles easily enough if you look at the photos. Took about 10 minutes with an impact driver and a couple sockets. Table seems flat, we didnt check with a straight edge. Good enough for backyard projects at least. You can see in the photo that the top of the table has the slag from a plasma or laser cutter piercing the metal, so you might need a flap wheel to clean it up. They also come covered in the cosmoline type "schmoo"m and when wiping the table down with some WD40 to clean it off, the wrag snagged on a lot of these. Careful running your hand over it.The included accessories are wasteful. The gloves had suspicious fibers poking out everywhere, so they didnt get unwrapped. Same with the "N95" mask... yeah... not putting that anywhere near a person's face. The goggles? Cool if you are cosplaying the weird 2000's Willy Wonka. Otherwise, we dont trust our safety to budget imported PRC gear.The hard accessories are pretty bad. Same cheap chip hammer that comes with every budget welding "kit", and a brush that looks 20 years old brand new. The clamps are plasma cut or something, super thin and ended up bending just trying to hang them for a photo.If these accessories were just sold on their own, they probably wouldnt. And considering these ones are headed right for the scrap pile... what a waste.
Jvwaterman 
