VEVOR 2 Speed SPA Pump, 56-Frame, AC220-240V Hot Tub SPA Pump, 3HP/200GPM/65.61ft High Speed or 0.4HP/100GPM/16.07ft Low Speed, 2" Port 90° Rotational Interface for Hot Tub, Tested to UL Standards
3.0HP
Questions and Answers
21 Questions
What are the high and low speed amperage ratings in this pump?
My old pump was a Century (A.O. Smith), part 7-193675-01, serial CA05-18. Type CXPM.
Is this compatible?
Its specs are 230 volts, 56 frame, 2" fittings, it used 8.8/3.0 amps, 60 HZ, RPM 3450/1795. It doesn't state the HP.
your pumps are described as 110-120v, but other text in the listings say they are 220v. Both can't be true. Please correct your listings to the correct voltage.
Can these pumps be wired to run at 120v instead of the 220v listed?
Hello, this pump model cannot be rewired to operate at 120V. It is designed exclusively for 220V power supply. Operating it on 120V power will lead to insufficient power, abnormal operation and potential damage to the unit.
By vevor
what protection for debris. what to do if debris in housing.
The VEVOR 2-Speed Spa Pump 3 HP is designed to be used with the spa/hot tub’s filtration system, which helps prevent debris from entering the pump housing.
If debris gets into the housing:
1-Turn off and disconnect power immediately
2-Close any spa isolation valves if installed
3-Open the pump housing/wet end and remove debris carefully
4-Inspect the impeller for blockage or damage before restarting
if this answer does not resolve the current issue, please contact us again for assistance.
By vevor
