VEVOR 3-Piece Cable Protection Ramp Set, Supports Up to 2,000 lbs Per Axle, Durable Cord Protection for High Foot Traffic Areas, Suitable for Indoors and Outdoors, Ideal for Office, Home, Warehouse

Yes. Absolutely and it's easy. I wanted more length for my driveway door opening. 4 Pieces was too long so I cut a piece in half and added on the end to fit.

Yes. We notched one end so it would sit flush to the wall and the cables could come up the wall to an opening. Just take your time with a fresh blade in a sheetrock knife/box cutter.

I never tried to cut them but I don't know why you couldn't . They are just rubber so it would be no big deal to cut them

Yes, but it's hard going.

It would have to be a VERY small garden hose. Most likely not though.

They will fit on top but not in the tracks - too small.

VERY UNLIKELY. I just stepped out to check, and I can barely get my index finger underneath. They are made to protect cable and/or wires.

no

I am not near that product now to test your question. My memory of it is that there is ample room for most electrical cable runs. However, water hoses I have used would have a diameter too large to fit without lifting the product off the ground. That said, if the hose is of the narrower type, a small amount of lift may be tolerable to you, depending on the application.

Yes, even a semi-truck could.

I'M SORRY, BUT I ONLY DRIVE MY 4 WHEEL ELECTRIC CART, MUCH LIGHTER THAN SUV, OVER IT; THE RUBBER DROP COVERS A FLEX METAL HOSE. David

Yes, but slowly. They move easily.