VEVOR Hairpin Table Legs 36 in Black Set of 4 Desk Legs 220 lbs Load Capacity Each Leg Hairpin Desk Legs 3 Rods for Bench Desk Dining End Table Chairs Carbon Steel DIY Heavy Duty Furniture Legs

It's would be fine mine is an inch too and they are perfect

I would measure the length. If it's an inch long then you'll need a smaller screw. TO compensate use wood glue for added strength

screws are 1", the bracket gives you a "very little" leeway./

It has been a while since I made three tables with the Hairpin legs, they were gifts, so I cannot measure, but my wood was 1/2 thick walnut. The screws held well and did not penetrate the top. I hope this helps.

I don’t know exactly how long they are, maybe an inch long. We used shorter screws we already had on hand. The piece of wood we used was only 3/4 in thick.

Sorry for the late reply. The srews are just alittle over 1 inch.

We have not used these yet but they are for a piece of pecan 8 feet by 30 inches. It will be a little smaller - but not much.

I made three end tables and the largest was 22x16, none had any wobble. I sat on one table, check strength, it held with no wobble.

Not sure but the design of the legs is such that there will always be a chance of some wobble because there 36 inches long and come to a point..

The mounting holes are 2” between, but could probably be altered to work.

2 & 1/16 between holes.

The holes on these legs are 2 inches apart four holes total hope that helps

I measured from center of screw to center of next screw. It measured 2 1/4 " apart.