VEVOR Hairpin Table Legs 24" Black Set of 4 Desk Legs 880lbs Load Capacity (Each 220lbs) Hairpin Desk Legs 3 Rods for Bench Desk Dining End Table Chairs Carbon Steel DIY Heavy Duty Furniture Legs

It's would be fine mine is an inch too and they are perfect

I would measure the length. If it's an inch long then you'll need a smaller screw. TO compensate use wood glue for added strength

screws are 1", the bracket gives you a "very little" leeway./

It has been a while since I made three tables with the Hairpin legs, they were gifts, so I cannot measure, but my wood was 1/2 thick walnut. The screws held well and did not penetrate the top. I hope this helps.

I don’t know exactly how long they are, maybe an inch long. We used shorter screws we already had on hand. The piece of wood we used was only 3/4 in thick.

Sorry for the late reply. The srews are just alittle over 1 inch.

The mounting holes are 2” between, but could probably be altered to work.

2 & 1/16 between holes.

The holes on these legs are 2 inches apart four holes total hope that helps

I measured from center of screw to center of next screw. It measured 2 1/4 " apart.

we used on a laminate flooring to hold up an island. We are more than stratified with the stability

Yes they are very stable.

Yes they do

Yes, they come with rubber boots that would cling to any surface.

I used these legs for a table on carpet floor. There is a flat stub that comes with these legs. I have no issue using it on the carpet.

Mine are on the porch, but if they are placed right, I think they would be fine on the carpet.