VEVOR 3 Phase Converter- 7.5HP 23A 220V Single Phase to 3 Phase Converter, Digital Phase Shifter for Residential & Light Commercial Use, 220V Input/Output (One DPS Must Be Used on One Motor Only)

If the power increases to 18hp, 28hp, or 50hp in the future, you only need to increase the number of our units. For instance, 18hp = 10hp*2, 50hp = 10hp*5. This way, you can increase as needed in the future, reducing your equipment costs.

Using our x ps is the most suitable. Using cps is your current choice, but it will be more troublesome to use. The XPS output below is a true three-phase power supply, and it can be paralleled. For example, if your current equipment power is 8hp, then you can purchase a 10hp unit.

This output is three-phase 220V and can be used with any three-phase 220V device, including ovens. However, pay attention to the wire gauge of the power cord. The instruction manual can be downloaded here: https://www.askpowe The file r.net/data/cps_user_guide.pdf is quite large, 70MB. https://www.askpower.net/data/cps_user_guide_min.pdf This is an image version, only 5MB in size.

The wiring connection is as follows: Power supply > Overcurrent protector > Switch > Phase converter > Motor (This motor is an additional motor). Connect LN to the 220V power supply; the voltage between these two lines should be 220V. Connect UVW to the motor. Note that this motor is an additional motor with the same power rating as the phase converter. You will need three-phase power, which should be drawn from the UVW terminals of the phase converter.

Connect LN to the 220V power supply; the voltage between these two lines should be 220V. Connect UVW to the motor. Note that the motor voltage rating needs to be changed to 220V. However, pay attention to the wire gauge of the power supply wire. 2. Method as a power supply. Below are the instructions for normal use of the inverter and the required wire gauge. Instructions for using the inverter.

We will provide instructions on using it as a motor starter or power supply below: 1. Usage as a motor starter. Below are the instructions for normal use of the inverter and the required wire gauge. Instructions for using the inverter. 1. Wire connection method as follows: Power supply > Overcurrent protector > Switch > Inverter > Motor

Dear Customer, Thanks for your inquiry. You measured the wrong location. The voltage measurement method for the inverter output is uv, vw, uw, using these three methods. Also, the current inverter is a motor starter, not a power supply. We will provide usage instructions below. If you wish to use it as a power supply, there are also methods.