VEVOR Deep Well Submersible Pump, 1.5 HP Output Power, 115V, 31.7 GPM Flow 276 ft Head, with 32.81 ft Cord, Stainless Steel Water Pump, for Industrial, Irrigation, and Home Use, IP68 Waterproof Grade

Turn the large center spring nut clockwise to increase both the "cut-in" (start) and "cut-off" (stop) pressure settings. For a 1.5HP motor, ensure you use at least 12 AWG wire to handle the current and always keep the breaker off during installation. if this answer does not resolve the current issue, please contact us again for assistance.

Connect your 230V power supply to the two outside "Line" terminals and the pump's wires to the two inside "Load" terminals. Secure all green or bare copper ground wires to the green screws on the switch base to prevent electrical hazards. Mount the switch onto a 1/4" NPT fitting on the water line near your pressure tank so it can sense the system's pressure.

The pump is equipped with a standard 2-pole high-speed asynchronous motor, with a rated full-load speed of 3450 RPM (revolutions per minute) at a frequency of 60Hz. The shaft connecting the impeller is a splined shaft.

The surge current of this electric pump is approximately 65A.

Yes, it runs from a 120V wall socket, but only after correct installation in a water well system. It is not a plug-and-play “drop and power immediately” device.

The water pump starts directly from the power supply and stops when the power is off. If other controls are required, you will need to configure a pressure switch and water storage tank according to your usage.