VEVOR 10 Ton Hydraulic Knockout Punch Kit, 1/2" to 2" Conduit Hole Cutter Set, KO Tool Kits with Puncher 6 Piece, Metal Sheet Driver Tools, For Aluminum, Brass, Stainless Steel, Fiberglass and Plastic

This product cannot cut a No. 16 stainless steel plate.

The mold and tie rod on the pipe can be installed and then the hole can be punched. The diameter of the pipe must be greater than 100mm

these punchs are specfic for conduit pipe and closest is 2.00"

The die rated for 2" conduit actually makes a 2.362" diameter hole. If that will not work you might make the next size down smaller hole and grind it out or nibble edges with that die. If you actually need a specific size you might find a manufacturer on line. There also might be a hole saw that would get you close. And if you have a mag drill you might be able to find a bit near the size you need.

these punchs are specfic for conduit pipe and closest is 2.00"

The die rated for 2" conduit actually makes a 2.362" diameter hole. If that will not work you might make the next size down smaller hole and grind it out or nibble edges with that die. If you actually need a specific size you might find a manufacturer on line. There also might be a hole saw that would get you close. And if you have a mag drill you might be able to find a bit near the size you need.

About this 10 Ton 1/2" to 2" Hydraulic Knockout Punch Driver, it can punch a 1.25 inch hole in a stack of cardstock paper.