After forging is completed and the ball valve and regulator are closed, the burner should be removed from the furnace in time, because the heat will be lost upward, which will cause the burner and nozzle to overheat. After forging is complete and the ball valve and regulator are closed, remove the burner from the furnace in a timely manner, as heat will dissipate upwards, which will cause the burner and nozzle to overheat. ( This step should be operated carefully to avoid scalding.
By vevor
Some of the oxygen holes above the burner need to be left out (preferably all of them, followed by some of them), and should not be completely covered by the orange sleeve.
When forging, the furnace needs to leave a certain space for the heat to dissipate, and the opening of the furnace cannot be completely covered with items. When forging, the furnace needs to leave a certain space for the heat to dissipate, and the opening of the furnace cannot be completely covered with items.
By vevor
Dear Customer, Thanks for your inquiry.
Yes. Therefore, it is recommended that customers:
1. All burners must be used at the same time. If some burners must not work, please remove the burners that do not work from the stove and do not leave them on the stove, otherwise the burners that do not work will conduct heat.
2. The oxygen holes above the burner need to be left out (preferably all, followed by partial), and should not be completely covered by the orange sleeve.
By vevor
