Please note: Once the protection mechanism restriction is lifted, if the pump runs dry for too long, the mechanical seal may burn out, causing severe damage to the pump and resulting in leaks. Therefore, please ensure that installation and operation are performed under the guidance of a professional. If you need to lift the restriction, please send us the product SN code. Thank you. If you have any questions, please feel free to contact us.
By vevor
If your pump is installed above the water level and the piping is long, we recommend installing a check valve on the pump’s suction line, which should resolve the issue : https://send.now/xtvelprdus5p
Hello, E006 indicates a low-water protection error, which is triggered under the following two circumstances:
Situation 1: The pump has not been primed with water beforehand. Please refer to Section 5.3, “PUMP COMMISSIONING AND OPERATION,” in the manual for the procedure.
By vevor
Situation 2: If the pump is installed above the water level, is located far from the water surface, or has a long suction pipe, and fails to draw water after 30 seconds of self-priming, the E006 self-protection mechanism will be triggered. In this case, we can grant you permission to disable the 30-second dry-run limit that triggers E006, thereby extending the allowable dry-run time.
If this response does not resolve your current issue, please contact us again for assistance.
By vevor
