Customer Reviews for VEVOR Skid Steer Mount Plate Thick Skid Steer Attachment Plate Steel Quick Attachment Loader Plate with 3 Additional Welding Rods Easy to Weld or Bolt to Different Accessories (5/16")

This product was well made and worked very well for my application. Welded to round bale hydraulic clamp

Very heavy. Fast shipping. Great price. I've bought three so far. I will buy more when I need them. I have two just waiting for a heavy project.

I went back and added welds where they were just tacked, but it’s a good plate.

Works good. Fits perfect. Had to add a little more weld to top plate because it was just tacked in a few spots. I assume this is for adjustments that may have to be made since it comes with a couple welding rods. For large, heavy implements I would definitely go with the heavier steel model.

used with kubota B2301

Very solid plate, well l made and fast free shipping. I will definitely look to Vevor for other products.

it was very tight and welds on the inside of the top lip hold the plate too high and prevent flush mating at bottom of plate. locking pins are not super happy but do lock all the way down. A little grinder work and works.easy to weld on.parenthetically, I purchased this several months ago for around $120 usd with $10 shipping to Alaska. Now I see both have increased quite a bit.Sorry, everyone. :)

This is a solid piece of steel. For the most part it’s good, except like others mention, it doesn’t fit, specially my Kubota L3301 front end loader quick connect mount. The hanger part at the top of the mount is fine, the width is fine, but the lower section where the pins slide through do not fit and the pins will not seat or lock in place. To remedy this, I cut notches with a torch to allow just enough room for the pins to seat and lock. There’s not enough room to use an angle grinder to clearance for the pins. I paid $158 for the 1/2” plate and I think it’s worth that.

Quality material and build. Did not fit on my bobcat out of the box. Had to grind off the welds on the top connection plate and move up so the pins would fully engage. Also had to inlet top connection plate to allow clearance for the pin handles to fully close without obstructions.

Steel is steel.. I bought because I thought the extra electrode was funny..it was..no flux left on them... won't do it again...