All
Account
Thomas Dudley Thomas Dudley
Great 6 ton press
So far I have cut keyways in 1 1/2 round stock and made a jug to bend up to 1/4" stock at a 45 deg angle. It works great. The down side is that the hydraulic ram doesn't want to come down square on to your work piece. I attached a 1/4 " inch piece of flat stock above and below where the ram comes through the cross bar. This acts as a guide, now it works great.
0
Phillip coy Phillip coy
Worked as advertised
0
Ken Ruhkamp Ken Ruhkamp
THE LITTLE RED PRESS THAT COULD
Low budget tool that worked pretty good. Used on rebuilding a 92 Dakota front end.
0
Steven Steven
Good But Buy Heavier Duty Steel Blocks
I was able to use the press - in combination with creative use of a sledge hammer - to remove & replace a wheel bearing. The 2 plates that come with the press are thin & bend easily (not nearly capable of withstanding anywhere close to 6 tons). You will need thicker, heavier duty steel blocks to complete most projects using only this press. That said, the press itself worked as advertised. Seems to be a very good product.
0
Elizabeth Eszterhas Elizabeth Eszterhas
On time as described
Hydraulic press as described, on time
0
Pedro Pesquera Pedro Pesquera
Hydraulic Shop Press
Very good, works great!
0
Jeff johnson Jeff johnson
Jack stand
Frame built really good..good quallity,the plate that jack is on could be a little beefier
0
Stephen Brazwell Stephen Brazwell
This little guy fits on my shop table
It is a little smaller than I expected but for the money it will work do the when I do the be control arm bushings on my suburban.
0
Ken Cissell Ken Cissell
Hydraulic Shop Press Floor Shop Equipment 6ton Jack Stand H Frame Red
0
Nick b Nick b
Great product
Liked everything except one of the legs were different one was angle iron other was u channel stock but I made it work asome for the price
0

855-385-1880 Monday to Friday, 08:00-17:00, GMT-7