Customer Reviews for VEVOR Hydraulic Shop Press 6 Ton H-Frame Hydraulic Press 13227lbs with Heavy Duty Steel Plates

Utilidad,buena relacion precio/valor

Works GREAT!!!!! I LOVE MY PRESS!!!!!!!! Presses pins and rods in and out!!!!! Takes up little space on my table!!!!

Low budget tool that worked pretty good. Used on rebuilding a 92 Dakota front end.

Frame built really good..good quallity,the plate that jack is on could be a little beefier

I was able to use the press - in combination with creative use of a sledge hammer - to remove & replace a wheel bearing. The 2 plates that come with the press are thin & bend easily (not nearly capable of withstanding anywhere close to 6 tons). You will need thicker, heavier duty steel blocks to complete most projects using only this press. That said, the press itself worked as advertised. Seems to be a very good product.

So far I have cut keyways in 1 1/2 round stock and made a jug to bend up to 1/4" stock at a 45 deg angle. It works great. The down side is that the hydraulic ram doesn't want to come down square on to your work piece. I attached a 1/4 " inch piece of flat stock above and below where the ram comes through the cross bar. This acts as a guide, now it works great.

Very good, works great!

Worked as advertised

Hydraulic press as described, on time

It is a little smaller than I expected but for the money it will work do the when I do the be control arm bushings on my suburban.