Was skeptical about buying this because of the reviews. Even bought a 40rpm replacement motor to slow it down incase it was too fast like people mentioned. Out of the box it worked good. Yes it slowed down enough to weld with. Didn't stop like people were saying. Also the ground clamp works good like it's supposed to. I did grind the paint off the bottom and clean any coating that was on the contactor for the ground. Since I had the 40rpm motor I put that on to try it and definitely was a good choice because it made it alot stronger with the lower rpm motor. I turned it way down and put pressure on it and the table kept turning. Definitely happy I bought it. Will post a video also

Easy to move on and off bench, Turns too fast, easy to tilt and clamp parts, ground wire looks small but work so far.

Bought this for a high production job. It works great!

I would have given 5 stars if the rpm wasn't so high. I replaced the motor on mine with one bought here on Amazon. You can select from several rpm ranges. The one I chose was the 40rpm one which slows the table down to 1.3 to 6.75 rpm. The last half of the adjustment knob there is little change though. It is a bit tricky since you need to remove the motor gear before you can get the motor out, and you are working down in a hole. I chipped off the dab of glue then used a Smith Little torch to heat the gear to smoking. I made a small gear puller as shown from a bent piece of aluminum to pull it off while hot. I will go back on the new motor cold with ease and you will need to put a dab of epoxy or otherwise to hold it. I also sanded the bottom rim where contact with the graphite/copper bar is as well as between the chuck and table. Degrease with brake cleaner at these locations for better electrical contact. Works well for small stuff which is what I bought it for. Mine is the one from Vevor.

Ok for the price. Has issues grounding to the piece. Will need to add a ground strap. Foot switch is el cheapo for sure.

Nice positioner,I added rubber feet, it just needs a larger chuck to come with it!

I like the rollers alot. Good alternative to spending several thousand on other brand rollers.- Christian ThamanUpdate* I have put about 500 hours on these bad boys and they are doing great. I've had about 3000 pounds on them and they turn it just fine. Really glad I rolled the dice in these!

I liked the ease to order and it was sent on time. It is the perfect size and easy to use

Great value for the price. Makes it easy to bevel pipe. JH

it is everything I expected