First off the top is 18ga. Where most of the similar tables are 14ga. The detent holes aren’t meant to be used however with a little grinding and a proper handle (picture) it works like the others. The punched holes for the trunion needs a washer ( picture) to add support. Because the top is so flimsy I added angle iron supports (picture) to beef it up. After all these mods it’s a pretty decent table.

Instructions weren’t great, but I got it together without any big problems. Table seems sturdy, casters are a nice feature, and I love how it folds up. I’ve used it for both welding and just as a work surface and it seems like it should hold up well for a cheap table.

Easy to put together

For the price its great. Since i didn't have 1-3000 for a heavy duty welding table this works great. Pretty sturdy have had a few hundred pounds on it and works great. Will do until i can afford a 1/2" table.Thank you again

Great table for the price. Assembled it in about 30-45 min. All pieces fit together well and had all the hardware. I dont know of you can find a better table for this price. I definitely recommend.

Shipped days before the expected date and is a great buy 10/10 buying many more

It is a good starter welding table

Ours arrived bent in one corner, the corner welds for the frame busted too. Most of the welds on this are just tack welds, which would normally be fine.Assembles easily enough if you look at the photos. Took about 10 minutes with an impact driver and a couple sockets. Table seems flat, we didnt check with a straight edge. Good enough for backyard projects at least. You can see in the photo that the top of the table has the slag from a plasma or laser cutter piercing the metal, so you might need a flap wheel to clean it up. They also come covered in the cosmoline type "schmoo"m and when wiping the table down with some WD40 to clean it off, the wrag snagged on a lot of these. Careful running your hand over it.The included accessories are wasteful. The gloves had suspicious fibers poking out everywhere, so they didnt get unwrapped. Same with the "N95" mask... yeah... not putting that anywhere near a person's face. The goggles? Cool if you are cosplaying the weird 2000's Willy Wonka. Otherwise, we dont trust our safety to budget imported PRC gear.The hard accessories are pretty bad. Same cheap chip hammer that comes with every budget welding "kit", and a brush that looks 20 years old brand new. The clamps are plasma cut or something, super thin and ended up bending just trying to hang them for a photo.If these accessories were just sold on their own, they probably wouldnt. And considering these ones are headed right for the scrap pile... what a waste.

My husband absolutely loved it

I'm a newbie welding with a small shop and this metal table has excellent construction and the perfect size. I'm extremely happy with it. Thank you very much by your fabulous product.