2 L Industry Heated Ultrasonic Cleaners Cleaning Equipment Heater W/timer Ce

Had the unit for a week, worked perfectly. Went to use the unit again, it blew the ground fault receptacle. Moved the unit to another circuit. Blew the ground fault. Opened a trouble ticket with Venor. They sent a email requesting a video of what was happening. Plugged the unit back into the same circuit , it worked flawlessly. The unit is working fine. I have used it at least 10 times, no problems. let the trouble ticket close. The unit has a 1 year warranty. Overall, the unit works well.

Cleaner shipped fast and works flawless. A little noisy, but that's how ultrasonic cleaners do their work. There's a bit of a learning curve on what cleaning solution works best for specific applications. Lots of helpful advice online, and with a little experimenting, you'll figure out what works for you. I'm a professional bicycle mechanic and do restorations on vintage bicycles. Usually the most time consuming and dirtiest part of these restorations is removing decades old accumulations of grease and dirt from the hubs, bearing and drive trains of the bikes. The pictured hub had at least 60 years worth of crud packed into every nook and cranny. After a couple of cycles in the cleaner with a 50/50 mix of a mild degreaser and water, the parts came out shining like new with just a water rinse and virtually no scrubbing. Cleaner works great on old chains with a rust removing cleaner. Not only is the surface of the chain cleaned but the ultrasonic waves break up gunk deep inside the chain roller to free them up to function properly. All while I'm free to work on other tasks I need to accomplish. I should have purchased this cleaner years ago.

The Ultrasonic Cleaner produced amazing results the first time I used it, cleaning two old rifle receivers of crud I did not even know existed! The unit appears to be limited to a 30 minute cycle which is OK, but my I got better results with a second cycle, and will probably give them a third cycle still. Keeping in mind that some of the crud may have been over 100 years old. You need to be careful with the lid, as it is very thin material and may be damaged if dropped, which is why I only gave a 4-star for quality. Everything else was very well built.

It is a great little machine. I have used it now about a 1/2 dozen different times. It works great. It is a little bit noisy, but these machines generally are.

I bought it for cleaning my 3d prints but also found it works great to clean my ammo.

Iuse it to clean my reloading brass.

Never given me any issue's would highly recommend

Perfect for cleaning small bike parts and chain

So far so good !