This is review for "VEVOR Outdoor Stair Railing, Fits for 0-5 Steps Transitional Wrought Iron Handrail, Adjustable Exterior Stair Railing, Handrails for Concrete Steps with Installation Kit, Matte Black Outdoor Handrail". Issues: 1) It is not Wrought Iron. Then again, almost no products are, the term is commonly misused. Appears to be mild steel. A magnet sticks to the base, posts, rails, brackets, end caps, and pedestal covers. The fittings for the rails' attachments are a non-ferrous alloy, perhaps zinc or other "pot metal" casting. 2) Packaging was Styrofoam, and was partly crumbled as received. Very messy and ecologically harmful. Some type of formed cardboard would be preferable. 3) Some of the holes were too small and needed to be enlarged. I used a 13/64" drill to fit the 5mm screws. Vendor refunded small allowance for the defect. 4) The aforementioned cast fittings had bad threads two locations, the screws stripped before even tightening. The fittings metal is weak. Probably drilling through and using one through bolt at each mounting (four total) would be more robust than the two individual screws at each mounting (eight total). Notes: I used conventional expansion bolts instead of the supplied anchor hardware. The posts are fairly sturdy. They will vibrate for a while if whacked. I added side braces for additional robustness. The rails are lighter gauge than the posts and reasonably strong. The hardware kit included one each additional of each type screw, nice. Also included was an decent quality adjustable crescent wrench, you'd pay a few dollars for at the store. Instructions were fairly clear.
Hamilton Herzberger 
