Customer Reviews for VEVOR Single Horn Anvil, High Hardness Rugged Round Horn Anvil Blacksmith,8.8Lbs Cast Steel Anvil,Compact Design and Stable Base, Forge Tools and Equipment, Metalsmith Tool for Bending and Shaping

I have a small shop in my garage and I am your average DIY. I have been looking for the right steel anvil (not cast iron) for my small projects. This anvil fits the bill, I had to pay a little more for the steel anvil but it's well worth it.

These anvils are great for the price per pound. Sure they need work and clean up so what. Cast steel anvils that are serviceable and cost effective are great for beginners and hardened pros alike.

For the money you cant beat it. if you are a beginner blacksmith don't waste your money on an antique anvil unless you happen to find a great buy, with that said I would never trade my peterwritght for one, but it is a great second anvil that I dont regret buying. Don't expect a perfect anvil, mine came with some small pitting on the face in a few spots, there was also casting flaws on the sides of the avil that were filled with putty. none of the imperfections would hurt the performance of the anvil. rebound is 75 to 80 percent. The pritchel hole is not very usable and the hardi hole is large for the size of anvil

The anvil has good rebound and far, no dents in the face. The hardie hole on mine measure 1" by 1 1/8". The edges need to be radiused and you need to clean the casting sand/grit out of the holes with a cold chisel. It's large enough to do what I need too and doesn't weigh so much that I can't move it around the garage.

22 Lb Anvil Blacksmith Anvil 10kg Cast Iron Round Horn Metal Forging Hardy Hole

Personnel, j’ai une mini forge ( forgeron )

I have been using this for about 5 months now and I 100% recommended it has held up through everything that I've done and everything I've shot at it it was a 132 pound animal but when I got it it was only a 126 pounds but I let vivor know about it and they were more than happy to work with me and gave me money off to make up the difference this is a very customer oriented company and I will definitely work with them in the future

The steel is not hard at all. When I hit it with my hammer it leaves dents in the metal

I am not a blacksmith so spending 1500 for a real anvil was not an option , but could never find a decent size one for the occasional user, until now. They shipped it in a small wooden crate. It is really nice and I have used it many times already for straightening bent tools etc. Just what I needed at a price I could afford.

I have waited to give this review because i was worried about longevity. I have punded at this anvil and ran it threw the paces. anything from chisels and ball peen hammers have had direct hits on the face with very small reflection. It did well with a 16 lb sledge hammer with overhead swinging. The surface is very flat and the edges were very sharp I filled my edges down a bit because i was worred about chipping. the hardy was 7/8 by 15/16 with lots of paint and some sort of crusty stuff set aside 5 hours with a file if you want to fix that. face was very hard with a 95 % rebound. This anvil has helped me get twice the work done that i did on my 80 lb railroad track joint in half the time.