Customer Reviews for VEVOR Hydraulic Shop Press, 6 Ton H-Frame Hydraulic Garage/Shop Floor Press, Adjustable Shop Press with Press Plates, Heavy Duty Hydraulic Press for Garage, Shop, Workshop

To begin with, I was amazed at the superior quality of this product. It is built like a tank. Not only is the quality exceptional, but the packaging is top notch; it came in perfect condition. Please note: Putting this together takes time and patience. Before tightening any bolts, be sure everything is level and plumb. Again, use your head! As with buying any tool, all tools must be checked for alignment and proper fitment. There are no instructions with this press, only a diagram. Study it. Outstanding results.

It's ok but wish I'd known but was so short. If I had known it needed to be put on top of a table or counter I wouldn't have purchased.

as expected and on time good value

Worked out perfect for a tight space

perfect size for my shop, I didn't want a big behemoth tool taking upspace in my shop, this is perfect, it's powerful enough to press a bearing on, thatz all I need... why buy a big contraption you'll only use once in a while. Great job as usual vevor.

I was able to complete the job I bought it to do but learned it is not tall enough to do some jobs if you want to do transmission work. Had to make some modifications to it to get the job done.

This product comb a lot sooner than expected, was very simple to put together, definitely built to last, exceeded expectations are all around

Love it and east to use. Small but mighty and thats exaclty what i needed for my garage and my scrapping business

perfect size for my shop, I didn't want a big behemoth tool taking upspace in my shop, this is perfect, it's powerful enough to press a bearing on, thatz all I need... why buy a big contraption you'll only use once in a while. Great job as usual vevor.

The press was rather easy to assemble. The only drawback is it takes 2 people to install the jack. The 2 other drawbacks is the table part needs a sleeve between the bolts If you tighten them you can't move the table without loosing the bolts. I just cut a couple pieces of round tube and made sleeves. The other drawback is the press plates. Unlike the plates on the harbor freight plates which are 1 inch thick and have different notches on all 4 sides this press has just 2 thin flat plates. Making it difficult to press different types of bearings etc. Other than that it's worth the money.