Customer Reviews for Plasma Cutter Air Plasma Cutter 40a Non-touch Pilot Arc Cut-40 110v/220v 12mm

The plasma cutter arrived earlier than expected it was packaged well. The plasma cutter is a very good quality there was a little bit of assembly required but other than that it was pretty much ready to go. I was a little bit confused on the 110-volt/220VBecause the 220 pigtail they sent with it does not fit any of the 220 outlets I've ever seen. So I just usually adapter plugged it in the 110V and it works perfect I'm very pleased with my purchase I even purchased a tankless water heater from Vevor Once I saw the quality of the plasma cutter so you'll be getting a review on that as soon as I get it and get it hooked up. I would definitely recommend this plasma cutter especially for the do-it-yourself guysThey're just going to use it for home projects.

Great addition to k my shop.

I used this for some metal fabrication and cutting old studs and exhaust manifolds off my truck works excellently.

I bought this for a maker space that I work at. Gets a fair amount of use and feedback has been great. A very basic unit but has adequate power for most simple jobs. The non-touch pilot arc feature was critical for me, and this machine is one of the least expensive offering that capability. So far, it has been a winner for us.

Awesome for the price...............................................................................

The machine is straight forward regarding assembly with the help of the internet but my machine came without an instruction manual

Got everything setup & it would not work & it just turn out to be the inner tip on gun was lose. So be sure to check that.. On 110v set on 25 at 55psi , I cut a pipe & the end of a 54 leaf spring, also turn it side way & wash off the leaf spring clamp.. Works greats & will come in handy for working on old trucks. Well that all folks...Sandman..

Great little machine for the price.Works great, I just need practice to be able to use it to it's full potential.

Very happy with the quality of this machine and that it came as a complete kit with the air filter. Replacement consumables are very common and easy to find. I just cut over 80 lineal feet of 1/8" mild steel over the course of a couple hours... machine set on the highest level... plugged into a 20 amp 240 volt circuit and it didn't miss a beat, didn't trip the breaker once. Only complaint is that the pressure gauge that came with the air filter only shows MPA.. had to do the math to convert to PSI. Setting it around 0.40 MPA (58 PSI) was about right.

Good price, good performance, decent quality. The only con I have is I don't think they have service parts for consumables. Fortunately I purchased the no contact model.