Customer Reviews for VEVOR 1680W MD50 Magnetic Drill 300 RPM Spindle Speed Electric Magnetic Drilling System with 2 Inch Boring Diameter and 2900 LBS Magnet Force

Being familiar with the Milwaukee brand, I was quite surprised and impressed with the quality and price of your product. Using a core drill on I-beams, it cut like a knife through butter. For a one-time use it was perfect. I would recommend this tool to anyone. Oh, the cutting oil feeder cup is a nice addition and works flawlessly.

Like my drill press a lot works perfect trade out drills beautiful magnet works wonderful well satisfied with my drill press thank you Amazon

bigger then thought

It works great. Drilled 1/2” steel like nothing

it appears it should work for moderate use.

Verygood for light duty work.

I had to drill 32 1/2” holes in a double frame truck frame on a truck I was building. The price of this drill was the same as renting one over the weekend. This seemed cheaper in the long run and if it survived the job I considered it pretty much free after that. It’s a Chinese drill but quality wasn’t too bad. I had to double check and tighten up a few loose screws and check a few connections with the on/off switch but other than that and a pack of cheap mag drill bits we were off and punching holes through truck frame like it was nothing! I use a much more expensive unit to line bore and sleeve semi truck axles at work and this unit did the job just as well. Magnet seems strong but doesn’t have any safety features to shut the drill off if the magnet comes off the metal surface. Just take your time and don’t put too much pressure on the drill. The “safety chain” that came with the drill was a piece of rope. I chuckled at that idea and used a scrap piece of light chain I had laying in the shop. I didn’t think much of the Oiler setup on the drill and after listening to the Oiler squeak for a few minutes took a set of snap ring pliers and took it off and manually lubed the cutting bit with a oil can. Highly recommend and would buy again even though unit seems to have held up very well so I doubt I’ll need to.

Everything is as it should be and a trial use showed it worked quite well. This really eases up some drilling operations.

The bits get stuck in the drive portion and I have to use vice grips and a hammer to remove them. The drill does have plenty of power for a 120 volt and it is a solid straight drive when drilling. I have used it to drill close to 50 holes thru 1" thick steel plate A36. Good deal for $330.00

I used this to drill forty-eight 9/16" holes in the flanges of W6-25 beams. It performed flawlessly. Precision set-up can be a bit fiddly but over-all I would recommend to anyone who is working on a tight budget.