Customer Reviews for VEVOR 12 Ton Exhaust Tubing Bender 1/2 Inch Square Hydraulic Hand Pump Tubing Bender Stroke 130mm Pipe Bending Tool within 90-180 Degree Steel Pipe Bender with 6 Dies

Using it right now to make a swing arm for a project 3 wheel bike with a 420cc motor. Good purchase WB

The Product works perfect i used it on a 1 inch roll cage and it bent it with ease

I usually don't do reviews. Don't know what to say. My story on this bender1st-this is a tube bender, measuring the OD(outside diameter) of aluminum tube. This is what I have and needed. Pipe is measured by ID( inside diameter)So, make sure you know what you have,tube/pipe from the startB-I have a shop, brand new, so no place to mount the base yet-so I skinned a tree just a little and mounted the base on it. Very happy I thought of that, thought outside the box per say3-since I had never done this before and only one aluminum tube so no room for error. I marked the center of the tube w marker, placed it in center of jig, rolled it towards the hold clamp and marked it there. Then placed it in hold clamp and started bending. It ended up being almost perfect. Luck/Skill=you decide. Placed a 2'x3' carpenter square on it marked the long side and cut off 1/4"D-this was exactly what I needed and affordable for me. I'm a DisVet so not a lot of money to waste or throw awayFifth-this works great, all manual, but I have more strength so for it is PERFECT and preciseInfinity/Last/Z-it is still mounter on tree(2 weeks now approx) still bending tube, for friends now, making boat hold on brackets and 4"tall rails around top of Jon boats

Its solid, works good. For price Delivery was prompt.

Perfect bender. Bends scedule 40 pipe with just a little heat

My husband wanted this to bend and re-route an exhaust pipe on a generator in our motorhome. He had it setup and the job completed in less than an hour. Portable and easy to use. Just what he was looking for.

This is a well built bender, I have only used it once, but it done what it was designed to do. The only downfall is you can't really bend short peaces, you need to have a long piece of pipe, bend your elbow and then cut it off.

We bought the UB-100 bender. Works great for what we need. Unlike the other review here, we found bending small sections not a problem at all. You just need to know where on your material the bend needs to be.