All

Customer Reviews

  • 4.8
  • 4.6
  • 4.6
  • 4.7
gennet80 gennet80
So far, so good. Nice little machine.
It is good product.
0
Steven Kies Steven Kies
Works well!
Using this to dry gpus after cleaning in sonic sink.Works well. Recommend flipping the temp sensor so it touches pcb instead of the elements.
0
S&Kion S&Kion
Had to change fan to load perfect not!
Great product but the fan noise is unbearable I changed it to a Noctua NF-A4x20 now it’s perfect
0
benjdelos64 benjdelos64
Easy to use
Made work much easier
0
Matt Matt
Good for medium volume runs
I am proficient at hand soldering, but am learning to use hot air. Learning the temperatures for my application took a few tries, but it cut my soldering time of a QFN component down more than half of the time. This is a must if you have to solder medium volume runs.
0
Mike gilchrest Mike gilchrest
Buy a proper cord.
Works good, fan is a little noises, power cord is a fire hazard. They cord included with the machine hot too hot to touch after being run for 15 minutes.
0
Amazon Customer Amazon Customer
Major assembly defect
For the money, this guy works well with a little hot air from above. I have used it several times for pick up and put down high pin count tqfp parts and makes working with packages that have “power pads” under the part actually workable. Cooling fan is a little annoying but I can live with it.
0
Elaina Elaina
Great job for my first time with it.
Just did my first job on this plate. Removing about 20 SMD Capacitors for a recap. Did its job very well! No issues.
0
David David
Worth the money!
Great product. Works well and meets the requirements needed to work on micro soldiering.
0
Lifesong Lifesong
Satisfactory performance though noisy and with a hard to read display
I've been using this for about a month to good satisfaction so far. I checked the temperature independently with an Omega thermocouple meter and found a +/- of 5~10 degrees F. Only three complaints, only one of which affect usability: (1) the unit is quite noisy while in operation especially after reaching and while maintaining set temperature, (2) the clear plastic overlay covering the digital display is difficult to read requiring me to turn off my bench light every time I want to check progress or change a setting, (3) the PCB support arms can only be tightened into place in the front and if they move on the back side the board can fall off onto the heating element too easily. This needs to be corrected first before considering a 5-star rating.
0

People Who Bought This Item Also Bought

855-385-1880 Monday to Friday, 08:00-17:00, GMT-7; Saturday to Sunday, 08:00 - 15:00, GMT-7 ©2009 - 2022 VEVOR All Rights Reserved