Unlock the full potential of your VEVOR Button Maker Machine with our comprehensive product manual. Designed specifically for the 2.28-inch/58mm Pin Maker, this manual is your ultimate guide to mastering the art of button making. Whether you are setting up your machine for the first time or troubleshooting specific issues, our manual provides step-by-step instructions that are easy to follow.
The ergonomic arc handle punch press kit is perfect for creating personalized buttons, and the included 100 pieces of button parts allow for endless creativity. The manual also features a special section on using the Button Maker with the Panda Magic Book, making it an ideal resource for crafting DIY gifts for children and special occasions like Christmas.
Enhance your crafting experience and ensure optimal performance of your VEVOR Button Maker Machine with this indispensable manual.
Safety Reminder
- This badge machine is only used for the intended purpose. Don’t apply in other applications that exceed safety considerations.
- Children cannot operate this product unless accompanied by an adult.
- Pay attention to safety during operation, and avoid crushing fingers
Button Maker Components
Button Maker Installation Steps
Model and Parameter
Button Maker Failures and Troubleshooting
| Failure Appearance | Possible Reasons | Troubleshooting |
| First time, press the iron cover downward and not absorbed to the upper mold | 1. Unsuitable operating method. 2. Too much lubricating oil in the upper mold. |
1. First-time downward press-up mold hinge is in a separate state. 2. Use a clean cloth or tissue to completely wipe it if too much lubricating oil is found on the upper mold. 3. When closing, the up and down mold must be on the same vertical line. |
| The second downward press part is not wrapped in | 1. Unsuitable operating method. 2. Unsuitable paper thickness. 3. Up mold screws loosen. |
1. The up and down mold must be on the same vertical line when closing 2. Use the stipulated thickness of paper. 3. Place the up mold on the machine body, the use the complimentary Allen key to fix the screws in the up mold internal hole center. |
| Badge pressed in but not firmly | 1. The downward press is not in place, not pressed to the bottom. 2. The paper is thinner. 3. (25 mm) Configured metal back consumables, do not place the washer |
1. Need to press the bottom when pressing downward. 2. Change to use a slightly thicker paper. 3. Right side mold place 2 mm thickness washer when using the metal back consumables. |
| Up mold unable to lift up after pressing, probably blocked | 1. The up and down mold position deviated. 2. The paper is incorrectly cut round or blocked by a foreign object. |
Use a sharp tool (such as a straight screwdriver) to align to the middle merge position clearance, which is between up and down mold, and pry open with the object like a hammer (Attention: Just tap it, generally, it will not be too tight) |
Recommended For Your Project
VEVOR Button Maker Machine, 2.28 inch/58mm Pin Maker with 100pcs Button Parts Manual
Reviews
There are no reviews yet.