Jon Jon
Greatly increases digging capiblity
Ordered the tooth bar for my l2501, with a 66" bucket the tooth bar was approx 1" too long. Cut a half inch out of either side of the center tooth and welded it back together. The tooth bar then fit great and it makes a huge difference in digging and the teeth are a little long but it works great for carrying logs.
Rudi Rudi
Tooth bar for front end loader
this tooth bar was a very good deal, the price was right, the delivery suited me and the unit worked perfect for my needs.
Carl Endsley Carl Endsley
Good buy for money/ But
This item is good for the price, but i did have to grind off both ends to fit in my John deere bucket. The bar came really bowed which helps keep it on. The teeth are tricky to get on. all and all ok
use your teeth for chewing!
Tough game changing addition to my loader bucket. This is money well spent. Digs more effectively, uproots vegetation quickly and decreases the number of passes required to clear debris!
Ricky Duck Ricky Duck
Bucket with teeth
Works great digging into bank and pulling small trees up
Tommy Willis Tommy Willis
Well built but would not fit over my 48" JD bucket. Had to modify.
Daniel Knittle Daniel Knittle
It'll work
Came slightly bent, but no problem installing. Haven't used yet because of the winter storms and rain. Hopefully will get a chance in a couple weeks.
David Privett David Privett
bolt on 66 inch toothed bucket bar
was not a exact fit but if figured that it would not be. just took out 1-1/4 inches of plate ,rewelded it and good to go. works well when fitted to bucket. I like the idea if I need it I can put it on if I need a finishing bucket I can just take it off. It takes a little time but it can be done with only one bucket instead of two.
elbert harris elbert harris
2 N 1
I have not used them at all. This was an impulse. I saw & I bought. They look very heavy.
Bryan McCoy Bryan McCoy
About what I expected
At this price point, I didn't expect it to be perfect. 1st thing to note, it's NOT clamp on. No clamps or even the the threaded holes you would need for a set screw to function. Second, was missing some hardware. Not a big issue, $4 at Tractor Supply and I was good to go. Lastly, teeth didn't fit on mount. Holes didn't line up even anywhere near close enough to put the pins through. Do not purchase these if you don't have an angle grinder. You will have to do a bit of cleanup on the bar to get the teeth holes to line up enough to beat in with a mini-sledge. All in all, solid purchase. The time it took me to make it work was well worth what I saved over a more expensive bar.

855-385-1880 Monday to Friday, 08:00-17:00, GMT-7