All
Account
Jimmy Jimmy
Almost great
Made very well. It is just what I wanted. I am using Pecan wood for the vise face. It is almost but not quite great. The one thing that would have put it at great is to help simplify the installation with a template pdf. I highly recommend it with or without the template. With the template, I would have rated 5 stars across the spectrum.
0
R. Boulden R. Boulden
No handle
The woodworking bench vise is minimal. The acme threading is rough but workable. I found some beech rod and some beech balls. I rotated my drill press table 90° used some clamps and drilled a hole for 3/8” dowel. I threaded the other end so I can attach the handle to the vise.I made jaws out of oak so the vise can get a good bite on the woodworking piece. I lubed the acme screw with lithium grease, wiping off any excess.You can spend hundreds of $$$ on a beautiful smooth turning vise. This vise is minimal but seems to be strong and functional.
0
Steve Steve
Retired
Had a problem as it arrived a bit banged up - customer service though was great. The vice was replaced and is now up and running. Not an expensive vice - but my first real wood working bench and the vice meets expectations!
0
James Milner James Milner
Good buy!
I am happy with this vice. I added hardwood faces, and it is working great!
0
Non Stop Horizon Non Stop Horizon
Lo buena que esta prensa
Muy, muy bueno, me ha ayudado mucho con mi trabajo y era la noticia que necesitaba.
0
Rod Norman Rod Norman
7 inch vise review
I have a 10.5 inch. That will be my bench vise. I will redesign this one as a tail vise.
0
Harry Bruce Harry Bruce
simple vise, well resolved for my putposes
This purchase was my introduction to Vevor. Upon receipt I immediately ordered another and together the pair were less than any single competitor. I use these daily and am very pleased. Bare bones tool easily outfitted to suit many configurations...strongly recommmend.
0
Jim Cusic Jim Cusic
Works as expected
Install was straight forward Installed on my workbench. Now just need to find projects to use it on.
0
williee55 williee55
very good vise
0
sean s sean s
could use some instructions, or even a template!
the photo shows the bracket facing the other way - i don't know if i did it wrong, but i love the action of it!
0

855-385-1880 Monday to Friday, 08:00-17:00, GMT-7