All

Customer Reviews

Non Stop Horizon Non Stop Horizon
nice trolley
smooth operation good quality still using mine works great
0
Phyllis D Phyllis D
0.5T
Great Value - Quality Product
Installed on a new Gantry Crane. No instructions or paper work on how to install. Would be nice to know how tight the adjustment bolt should be. Works good.
0
Mike Mike
1T
Nice and heavy duty
The trolley wheels are very smooth in action and the construction is heavy duty. That being said the welds that hold the main bolt in the sleeve are very porous. I know that this is not a structural or loadbearing component but would have liked to see better welding on this sleeve.
0
royc10 royc10
0.5T
Not exactly as pictured but good never the less.
This item was used for a common house supporting beam that is in my garage. Turns out the trolley will barely fit the beam. Be sure your beam is not too wide to fit between the roller flanges. Also, the through shaft that holds the halves together and the hook-eye, includes two nuts you lock together (I used Loctite red on them as well), instead of the self locking castle nut shown.Overall, the unit is substantial and I would expect it to hole a ton as rated. But note that the beam has to be able to support a full ton on its flange or you risk serious injury. I did not receive any installation information and the box looked opened and re-taped, although it may have simply been taped due to the weight of the object All parts were included.I am using it with a 1-ton chain hoist.As a one ton beam trolley, I would recommend it as long as the safety rules are followed. I do not consider it "heavy duty".
0
michael michael
1T
Ok
Paint could have been a better quality and have Grease fitting.
0
Family Family
3T
Easy to install
Use this for a garage trolley and my kids use it as a ride in the garage. Very easy to install and setup on the I beam.
0
James James
2T
Good quality for the price.
The chains where not overly oil or grease and did not jammed when rapidly spinning the chain
0
mcmckoy43 mcmckoy43
0.5T
The little trolley that could
Stout trolley but make sure your I beam has at least 2.75” clear height for wheel clearance and sloped surface is better tan flat as well.
0
Eric M. Eric M.
0.5T
Seems solid, adjustable width using washers
The instructions made it obvious it was made in China, but it seems capable of holding a lot of weight. I bought it for a future project and haven’t used it yet to carry weight. It was one that would fit my I-beams so I hope it works. I am paid to make a review.
0
Bob1234 Bob1234
0.5T
Seems like it will work...
It’s a little narrow. Really pay attention as to how wide your beam is. I have a Harbor Freight 1/2 ton also. It’s about an inch wider. This particular beam trolly probably would not work where I have the harbor freight beam trolly. Seems like it will work just fine. Paint a little scuffed but packed well enough.
3 Ton Push Beam Track Roller Trolley Capacity 6600lbs Heavy Loads Solid Steel
0
855-385-1880 Monday to Friday, 08:00-17:00, GMT-7 ©2009 - 2022 VEVOR All Rights Reserved