All
Account
Vevor Customer Vevor Customer
125 mm
It looks good. it nicely machine and opens and close smooth
It looks good .it nicely machine and opens and close smooth. For the prize cant go wrong.
0
Buyer Buyer
75 mm
Great value for the oney
some quick filing to remove sharp edges, degrease mount and tram. Basic vise that exceeded my expectations based on other reviews. If you want high end accuracy and quality quit shopping for bargain basement prices as this is good quality for the money and I would purchase again.
0
happy peeps happy peeps
150 mm
Came with rust on the bottom
Good enough for home use. I haven't checked it on a surface plate yet. Don't expect a kurt equivalent vise for $100. Unless your machinist Jesus, that's just not gonna happen. Overall: pretty good for the money
0
Vevor Customer Vevor Customer
75 mm
Great value for the money
No complaints good vise for the price.
0
Ralph Taylor Ralph Taylor
125 mm
It is a good value.
It's just as expected. Works good
0
James Boler James Boler
150 mm
You tube will handy.
Seems to be good for the price. Instruction manual seems to be translated from, Chinese? Unintelligible for the most part. I'll muddle through.
0
sb mulch sb mulch
150 mm
good for cheap vise
good for a cheap vise has a screw to take out the kick
0
william spires william spires
125 mm
Great value
Looks and works as good as the $500 vice.
0
K.M. Cardalico K.M. Cardalico
125 mm
Does the job.
Maybe a little overpriced but good vise.
0
Bob Bob
125 mm
Very impressive for such a low price tag
I purchased two 4" vises to be used together on a small Grizzly mill. The size it just right for the machine. I like the fact they provide keys so you can trim the keys to fit the table. The keys also provide a positive lock to keep the vises in-line while working. The -1 star is because of the height difference in using a pair on the machine. The vises are not book ends to each other. My examples are .012 different in height so I will have to shim 1 vise so they are the same working height. The milled keyed areas under the vise are not the same to each other as well. Also 1 handle was not broached all the way therefore it would not slide onto the hex vise screw fully. So the vises need a little TLC before using them for other projects in the garage. I'm happy I didn't spend $1000 for kurt vises when with a few hours of tuning these vises will be more than fine for my intended machine. These vises are not for real CNC work as the vises are not held to the tightest tolerances. For the price they can't be beat.
0

855-385-1880 Monday to Friday, 08:00-17:00, GMT-7