All

Customer Reviews

Marvin R Persinger Marvin R Persinger
work great
good quality for the cost
0
Rooster Rooster
quality product
Great fit and finish. Adapted to a colorado xt pontoon boat.
0
Sam Sam
does its job, once you set it up
Overall I am pleased now that this is setup on the transom of my dinghy.To make this work I did need to drill out a larger hole in one of the holes on the rod holding the wheels. Otherwise when the boat was propped up correctly, the pins would not fit through.
0
Luc Dufour Luc Dufour
Excellente Qualité et très bien construit
0
Aarcha01 Aarcha01
Great value and quality compared to others.
The wheels arrived promptly and were packaged in a manner that they could not be damaged. I was surprised the quality of the steel frames and sturdiness of the wheels. The instructions weren’t great, but if you measure twice or (maybe even three times) :) before drilling your holes, you should be fine. I highly recommend these!
0
Robert C Robert C
Great wheels for my Jon boat
Work perfectlyOne exception... the rings on the pinsLaunched the boat ans went to flip the wheels upPulled on the ring, it uncoiled just as the pin came outI watched the pin sink to the bottomAt least the ring was attached to the safety cord
0
Jeff Stearns Jeff Stearns
Sturdy and easy to install. Retaining pins are somewhat hard to remove.
These wheels are sturdy and easy to install. I installed them by myself with a few hand tools in half an hour.I can now wheel my 110 pound dinghy down a set of concrete stairs, across a rocky shoreline, and into the water. This used to be difficult with two people, but I can now do it all by myself.My only complaint would be the retaining pins which hold the struts in place. You can pull the lower pin and flip the strut up out of the water. That's the idea, anyway. In reality, the retaining pins are hard to remove and install. The pins have a spring-loaded ball which acts as a detent, and that ball tends to stick in place when you try to install or remove the pin. It may get better if I can pack some grease into it; I haven't tried that yet.You may also want to tie a line to the pins so you don't lose them if you drop them in the water.I've just been leaving the wheels down when the boat is in the water. They add some drag but it's not a significant problem for me.
0
C Williams C Williams
Sturdy
Impressed by the quality. My plans are to paint these to match my all black hard floor inflatable. To my surprise they showed up completely deburred and bead blasted with a nice matte finish. Made my job much easier. Tires feel like they'd handle over 300lb with no issue, nice tread. Pins fit snug, no slop, and no fighting to insert. The only negative way missing one valve cap and I am OK with that.
0
855-385-1880 Monday to Friday, 08:00-17:00, GMT-7 ©2009 - 2022 VEVOR All Rights Reserved