This tool worked to press out rear axle bearings from my 2007 4Runner. As others have commented, I couldn't use a HF 20T press as delivered. The two channel irons for pressing against are welded together and the axle tool won't fit between. I got two 27 inch lengths of 5X9 channel from a steel supplier to replace the HF part. This allowed the axle and tool to be installed in the press. The difficulty came because the 5" height of the channel iron was about 1/8" more than the inner distance between two flanges on the press tool. So, the channel iron couldn't close up against the press. I ground the flat surface of the lower flange on two sides until the channel iron cleared. That took longer than pressing the bearings off. Maybe smaller channel iron would work too. The 5X9 are pretty heavy and didn't even notice the pressing.
heavy duty 
