VEVOR High Pressure Hand Pump 3 Stage Airgun PCP Pump 4500PSI Manual

Discover the ultimate guide to mastering your VEVOR High Pressure Hand Pump 3 Stage Airgun PCP Pump 4500PSI Stirrup Pump Air Rifle Filling Stirrup Pump (30MPA) with our comprehensive product manual.

Designed with user-friendliness in mind, this detailed manual will walk you through every step of setup, operation, and maintenance, ensuring you get the most out of your high-pressure hand pump.

Whether you are a first-time user or a seasoned pro, our manual provides invaluable troubleshooting tips and optimization techniques to enhance your experience. Download now to unlock the full potential of your VEVOR High Pressure Hand Pump and enjoy seamless air rifle filling with ease and precision.

Hand Pump User Manual

READ THESE INSTRUCTIONS CAREFULLY TO AVOID POSSIBLE INJURY OR PROPERTY DAMAGE.

Important Safety Instructions:

CAUTION: To reduce the risk of electrical shock or electrocution,

• Do not disassemble. Do not attempt repairs or modifications. Refer to qualified service agencies for all services and repairs.
• Please do not use this product in or area where it can fall or be pulled into water or other liquids.
• Do not reach for this product if it has fallen into liquid.
• Use this Air Compressor with 12-volt DC systems only.
• This product should never be left unattended during use.

WARNING: To prevent injuries,

• Never allow children to operate this Air Compressor. Close supervision is necessary when this Air Compressor is being used near children.
• This Air Compressor will become very HOT during and immediately after. Do not touch any part of this Air Compressor with bare hands, other than the On/Off switch, during and immediately after usage.
• Do not use this product near flames or explosive atmospheres or where aerosol products are being used.
• Do not operate this product where oxygen is being administered.
• Do not pump anything other than atmospheric air.
• Never use this product while sleepy or drowsy.
• Do not use any tools or attachments without determining the maximum air pressure for that tool or attachment.
• Never point any air nozzle or air sprayer toward another person or any part of the body.
• Wear safety glass or goggles when operating this product.
• Use only in well-ventilated areas.

Operating Instructions

Please read and follow the operating instructions carefully to ensure you enjoy the convenience and best use of your Air Compressor.

ATTENTION

• This product has a built-in temperature switch and will stop at about 85℃.
• The compressor will restart when the temperature drops to about 80℃.
• Do not out this product to get wet.
• Do not put this product near a high-temperature area.
• Do not connect this product directly to 12 12-volt source (battery); always fuse the power wire.
• Do not take this product apart;  attempting anything  on this label will void the warranty

How to Use the Hand Pump

1. Remove compressor, receiver drier or accumulator, orifice tube or expansion valve.
2. Flush the condenser and evaporator using a NON-OIL BASED A/C flush. On expansion valve systems, THE VALVE MUST BE REMOVED before the evaporator can be flushed. FLUSHED CONDENSERS FROM OUTLET TO INLET AND EVAPORATORS FROM INLET TO OUTLET.
   Warning: Newer Style condenser designs are very hard, and sometimes it would be impossible to do flush. In those cases, it is suggested that the condenser should be replaced if the compressor has a significant failure.
3. Drain all the oil from the new compressor and dispose of it according to local, state and federal laws. NOTE: If your compressor has a drain plug, you must open it up and drain what oil is in there, too.
4. Install half of the oil charge into the compressor and the remainder throughout the system. Turn the compressor shaft 8-10 complete revolutions to lubricate the front seal and other internal parts.
5. Install a new receiver, dryer, or accumulator and a new orifice tube or expansion valve.
6. Evacuate the A/C system for a minimum of one hour.
7. After evacuation, install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
8. Start the engine with A/C controls on MAX AIR with open doors and windows.
9. Add the remaining refrigerant charge as the manufacturer has called for.

CAUTION: This Air Compressor will become very HOT during and immediately after use. Never touch the Air Compressor or fitting connected to the Air Compressor other than the On/Off switch with your bare hands during or immediately after usage.

 

VEVOR High Pressure Hand Pump 3 Stage Airgun PCP Pump 4500PSI Manual