2 X Cylinder Head 18mm For Ford F-250 F-350 F-450 F550 6.0l Powerstroke Diesel

Seems well built and strong. I have not used it yet, but I am fairly sure it will work well. The “forks” fold up or can be unpinned easily, which I like. The complete unit with forks folder can sit against a wall for much easier storage.

I purchased this because I liked the design. I can leave the frame installed and either fold up the legs (issues), or remove the legs until I need them. Overall, it is a good design and built relatively well. The welds are good and neat and the steel used is robust enough to indicate that it will carry the designed load. The problem, for me, is that the holes on one side doesn't like up well. It lines up enough to fit the pin when extended, but not when folded up. The problem is on the frame end and just not worth the hassle of sending back for replacement. I think the company knows this and knows most will simply grind the hole out enough to \"make it work.\" It is a shame because the system is \"almost right.\" I'm sure some are shipped out and work perfectly fine. Perhaps ordering from Vevor directly gets you a more quality assured product, but mine is an almost complete kit that I will have to finish out. Otherwise, I expect it to do what I need to and that is to lift and move heavier items around my work area.

even at full blast must be super close to heat

I use these to move residential air conditioners on the back of my tractor. They work perfect. Good quality for the price. The forks can also be folded upward if you need to stow them or easily removed if need be.

I mounted this on my new Holland 35 hp. I have used to move a IBC water tote around the farm and it works very well, I like that the forks foal up and out of the way when necessary. Paint or powder coat could be better but an excellent value.

In all fairness, I reluctantly ordered these fold down 3-point forks to move pallets of lumber and set average logs on the mill. Loader forks were out of my price range at this time. I never intended to use them for extreme lifting, but of course, that's what I needed when they arrived, (two packages, a week apart) Coming off a two week bad spell with a tweaked back, I needed to get a large log onto the mill. Advertising listed them at 2200 lb rated. I put them on the tractor (1986 Ford 38HP) and set them down next to this particular log, then rolled the log onto the forks and shortened the top link to keep it in place.When I lifted the 3-pt the tractor grunted some but it lifted, so I backed up to the mill and set it on the rails... Done, every body can relax again. Turns out the my Log Weight Pro app says that log weighed 2780 lbs! [25" x 13' 8" Eastern Hemlock... look it up] I DO NOT recommend anyone else over load any equipment, and had I looked up the weight beforehand I would not have challenged fate. No cracks, bends, or any signs of my abuse so this one gets 5 stars. Sidenote: I will be adding 6" chain locks to keep them upright when not in use. [Danger] I'll be recoating them with a quality bed liner in spring. But nobody will cut the parts out (so you can weld them) for the price. Fold up forks, carry-all, round bales, slabs, log loader on a ground level sawmill.

Everything works great only complaint is the clips on the end of the pins are small and need to be heavier duty

This thing paid for itself the first time I used it! It is quite well built and I had looked for something similar for quite a while. Simple assembly took just a minute and I was ready to go.

Product arrived and needed to be repaired due to a couple of the anchor straps were coming apart from the seems. Company credited me 15% to get repaired locally.

This is a great squat rack, very strong and stable. I can easily do pull-ups with no problem. Great buy!